diff --git a/Variant-IBUS.md b/Variant-IBUS.md
index b7abf7c..47ea275 100644
--- a/Variant-IBUS.md
+++ b/Variant-IBUS.md
@@ -5,13 +5,13 @@ Default number of channels for IBUS in config.h is 14.
 ## Wiring:
 * Connect green wire to IBUS port of your receiver. By default, IBUS variant is using right sensor cable(shorter)
 
+⚠ Red wire from sensor cable delivers 15v !!!
+Use 3.3v from programming port, 5v from hall sensor cable, or a voltage regulator.
+
 ## Troubleshooting:
 
 If the board is beeping
 * Check the number of channels, even if you transmitter only handles 6 channels, you receiver might transmit more channels
 * Make sure you enabled PPM on your transmitter
 * Make sure you are using the sensor cable(left or right) selected in config.h
-* On some boards the wire colors might differ, try the blue wire
-
-⚠ Red wire from sensor cable delivers 15v !!!
-Use 3.3v from programming port, 5v from hall sensor cable, or a voltage regulator.
\ No newline at end of file
+* On some boards the wire colors might differ, try the blue wire
\ No newline at end of file