diff --git a/Variant-PWM.md b/Variant-PWM.md
index ca3bb44..e04d816 100644
--- a/Variant-PWM.md
+++ b/Variant-PWM.md
@@ -4,9 +4,9 @@ This variant can be used with Pulse Width Modulation RC Receivers.
 ## Wiring:
 * Connect channel 1 of your receiver to blue wire and channel 2 to green wire. By default, PWM variant is using right sensor cable(shorter) to minimize noise
 
+⚠ Red wire from sensor cable delivers 15v !!!
+Use 3.3v from programming port, 5v from hall sensor cable, or a voltage regulator.
+
 ## Troubleshooting:
 If the board is beeping:
-* Make sure you are using the sensor cable(left or right) selected in config.h
-
-⚠ Red wire from sensor cable delivers 15v !!!
-Use 3.3v from programming port, 5v from hall sensor cable, or a voltage regulator.
\ No newline at end of file
+* Make sure you are using the sensor cable(left or right) selected in config.h
\ No newline at end of file