diff --git a/Variant-PWM.md b/Variant-PWM.md
index 1943cda..9b5aff8 100644
--- a/Variant-PWM.md
+++ b/Variant-PWM.md
@@ -28,7 +28,7 @@ Proceed with [calibration](https://github.com/EFeru/hoverboard-firmware-hack-FOC
 ## :toolbox: Troubleshooting:
 If the board is [beeping](https://github.com/EmanuelFeru/hoverboard-firmware-hack-FOC/wiki/Diagnostics)
 * Make sure you are using the sensor cable(left=CONTROL_PWM_LEFT or right=CONTROL_PWM_RIGHT) selected in config.h
-* You might have a defective input, because of a fried resistor or MCU pin (e.g. [issue](https://github.com/EFeru/hoverboard-firmware-hack-FOC/issues/244)), you can configure the firmware to work on the other cable
+* You might have a defective MCU input, a missing 101 smd resistor or with too high resistance (e.g. [issue](https://github.com/EFeru/hoverboard-firmware-hack-FOC/issues/244)), you can configure the firmware to work on the other cable
 
 If you get unwanted movements, check the wiring section.