From 4c80a2ca8a33873f6069de5417c39fd10365ea94 Mon Sep 17 00:00:00 2001 From: Candas1 Date: Wed, 16 Dec 2020 23:17:11 +0100 Subject: [PATCH] Updated Variant Nunchuk (markdown) --- Variant-Nunchuk.md => Variant-NUNCHUK.md | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) rename Variant-Nunchuk.md => Variant-NUNCHUK.md (81%) diff --git a/Variant-Nunchuk.md b/Variant-NUNCHUK.md similarity index 81% rename from Variant-Nunchuk.md rename to Variant-NUNCHUK.md index e02dbfd..2d551c6 100644 --- a/Variant-Nunchuk.md +++ b/Variant-NUNCHUK.md @@ -2,7 +2,7 @@ This variant can be used with Wii Nunchuk (not the Wiimote). ## Wiring: * Connect blue wire to SCL and green wire to SDA on right sensor board cable(shorter) -* 100k Pull up resistors connected to 3.3v are recommended to prevent issues when nunchuk is disconnected +* 100k Pull up resistors connected to 3.3v are recommended to prevent the board to go full speed if nunchuk is disconnected |SCL|--|3.3v| |-|-|-| @@ -18,5 +18,6 @@ Proceed with [calibration](https://github.com/EmanuelFeru/hoverboard-firmware-ha If the board is beeping * On some boards the wire colors might differ, try switching blue and green cable +* Keep cable short, use shielded cable, use ferrits, stabilize voltage in nunchuk