diff --git a/Control---PPM.md b/Control---PPM.md
index dac7e0f..6960f9c 100644
--- a/Control---PPM.md
+++ b/Control---PPM.md
@@ -11,7 +11,7 @@ If the board is beeping
 * Check the number of channels, even if you transmitter only handles 6 channels, you receiver might transmit more channels
 * Make sure you enabled PPM on your transmitter
 * Make sure you are using the sensor cable(left or right) you selected in config.h
-* On some board the wire colors might differ, try the blue wire
+* On some boards the wire colors might differ, try the blue wire
 
 ⚠ Red wire from sensor cable delivers 15v !!!
 Use 3.3v from programming port, 5v from hall sensor cable, or a voltage regulator.
\ No newline at end of file