diff --git a/Variant-PPM.md b/Variant-PPM.md
index 0f96b4d..9d28501 100644
--- a/Variant-PPM.md
+++ b/Variant-PPM.md
@@ -35,6 +35,6 @@ If the board is [beeping](https://github.com/EmanuelFeru/hoverboard-firmware-hac
 * Make sure you use the PPM port on your receiver
 * Make sure you are using the sensor cable(left=CONTROL_PPM_LEFT or right=CONTROL_PPM_RIGHT) selected in config.h
 * On some boards the wire colors might differ, try the blue wire
-* You might have a defective input, because of a fried resistor or MCU pin (e.g. [issue](https://github.com/EFeru/hoverboard-firmware-hack-FOC/issues/244)), you can configure the firmware to work on the other cable
+* You might have a defective MCU input, a missing 101 smd resistor or with too high resistance (e.g. [issue](https://github.com/EFeru/hoverboard-firmware-hack-FOC/issues/244)), you can configure the firmware to work on the other cable
 
 If you get unwanted movements, check the wiring section.
\ No newline at end of file