From 843e847a3228617ab7a04950a80fe385893d73b9 Mon Sep 17 00:00:00 2001 From: Candas1 Date: Tue, 14 Feb 2023 08:33:47 +0100 Subject: [PATCH] Updated Variant PPM (markdown) --- Variant-PPM.md | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/Variant-PPM.md b/Variant-PPM.md index 0f96b4d..9d28501 100644 --- a/Variant-PPM.md +++ b/Variant-PPM.md @@ -35,6 +35,6 @@ If the board is [beeping](https://github.com/EmanuelFeru/hoverboard-firmware-hac * Make sure you use the PPM port on your receiver * Make sure you are using the sensor cable(left=CONTROL_PPM_LEFT or right=CONTROL_PPM_RIGHT) selected in config.h * On some boards the wire colors might differ, try the blue wire -* You might have a defective input, because of a fried resistor or MCU pin (e.g. [issue](https://github.com/EFeru/hoverboard-firmware-hack-FOC/issues/244)), you can configure the firmware to work on the other cable +* You might have a defective MCU input, a missing 101 smd resistor or with too high resistance (e.g. [issue](https://github.com/EFeru/hoverboard-firmware-hack-FOC/issues/244)), you can configure the firmware to work on the other cable If you get unwanted movements, check the wiring section. \ No newline at end of file