diff --git a/Variant-IBUS.md b/Variant-IBUS.md
index 6ffb578..b3ed29c 100644
--- a/Variant-IBUS.md
+++ b/Variant-IBUS.md
@@ -9,10 +9,9 @@ Use CONTROL_SERIAL_USART3 and FEEDBACK_SERIAL_USART3 for the right sensor cable(
 IBUS_NUM_CHANNELS is the number of channels for IBUS and is 14 by default. As an example Flysky fs-i6ab or RX2A receivers are sending 14 channels even when used with a 6 channel transmitter<br>
 
 ## Wiring:
+* Connect your receiver VCC to 3.3v from programming port, 5v from hall sensor cable, or a voltage regulator, ⚠️ Red wire from sensor cable delivers 15v !!!
 * Connect IBUS/Servo port of your receiver to green wire on the cable selected in config.h
-
-⚠️ Red wire from sensor cable delivers 15v !!!
-Use 3.3v from programming port, 5v from hall sensor cable, or a voltage regulator.
+* Connect the receiver to ground, ⚠️ On some boards, the black wire is 15v !!! Check with a multi-meter to make sure 15V and ground are not swapped
 
 ## Transmitter configuration:
 * Enable IBUS