From c8c3b8eb2072220486d4736b441bdaedd8b3517d Mon Sep 17 00:00:00 2001 From: Candas1 Date: Thu, 21 Apr 2022 09:56:39 +0200 Subject: [PATCH] Updated Variant NUNCHUK (markdown) --- Variant-NUNCHUK.md | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) diff --git a/Variant-NUNCHUK.md b/Variant-NUNCHUK.md index 9535a8a..12936e1 100644 --- a/Variant-NUNCHUK.md +++ b/Variant-NUNCHUK.md @@ -1,6 +1,6 @@ This variant can be used with Wii Nunchuk (not the Wiimote). -## Wiring: +## :electric_plug: Wiring: * Connect nunchuk's VCC to 3.3v from programming port or from a voltage regulator, ⚠️ Red wire from sensor cable delivers 15v !!! * Connect blue wire to SCL and green wire to SDA on right sensor board cable(shorter) * Connect nunchuk to ground, ⚠️ On some boards, the black wire is 15v !!! Check with a multi-meter to make sure 15V and ground are not swapped @@ -12,10 +12,10 @@ This variant can be used with Wii Nunchuk (not the Wiimote). Recommendation: Nunchuk Breakout Board https://github.com/Jan--Henrik/hoverboard-breakout -## Calibration: +## :control_knobs: Calibration: Proceed with [calibration](https://github.com/EFeru/hoverboard-firmware-hack-FOC/wiki/Input-Calibration) for better control. -## Troubleshooting: +## :toolbox: Troubleshooting: If the board is [beeping](https://github.com/EmanuelFeru/hoverboard-firmware-hack-FOC/wiki/Diagnostics) * On some boards the wire colors might differ, try switching blue and green cable