diff --git a/Variant-IBUS.md b/Variant-IBUS.md
index f33c69f..cc36f99 100644
--- a/Variant-IBUS.md
+++ b/Variant-IBUS.md
@@ -24,4 +24,5 @@ If the board is [beeping](https://github.com/EmanuelFeru/hoverboard-firmware-hac
 * Check the number of channels, even if you transmitter only handles 6 channels, you receiver might transmit more channels
 * Make sure you enabled IBUS on your transmitter, on some models it is activated together with PPM
 * Make sure you are using the sensor cable(left or right) selected in config.h
-* On some boards the wire colors might differ, try the blue wire
\ No newline at end of file
+* On some boards the wire colors might differ, try the blue wire
+* You might have a defective input, because of a fried resistor or MCU pin (e.g. [issue](https://github.com/EFeru/hoverboard-firmware-hack-FOC/issues/244)), you can configure the firmware to work on the other cable
\ No newline at end of file