diff --git a/Control---PPM.md b/Control---PPM.md
index 6960f9c..5a80e87 100644
--- a/Control---PPM.md
+++ b/Control---PPM.md
@@ -10,7 +10,7 @@ Default number of channels for PPM in config.h is 6.
 If the board is beeping
 * Check the number of channels, even if you transmitter only handles 6 channels, you receiver might transmit more channels
 * Make sure you enabled PPM on your transmitter
-* Make sure you are using the sensor cable(left or right) you selected in config.h
+* Make sure you are using the sensor cable(left or right) selected in config.h
 * On some boards the wire colors might differ, try the blue wire
 
 ⚠ Red wire from sensor cable delivers 15v !!!