diff --git a/Variant-TRANSPOTTER.md b/Variant-TRANSPOTTER.md
index 7ab84af..59d8706 100644
--- a/Variant-TRANSPOTTER.md
+++ b/Variant-TRANSPOTTER.md
@@ -2,7 +2,7 @@
 [Transpotter build from Lucy](https://github.com/NiklasFauth/hoverboard-firmware-hack/wiki/Build-Instruction:-TranspOtter)
 
 ## Wiring:
-* Connect the potentiometer/hall sensor VCC to 3.3v from programming port or from a voltage regulator, ⚠️ Red wire from sensor cable delivers 15v !!!
+* Connect the potentiometer VCC to 3.3v from programming port or from a voltage regulator, ⚠️ Red wire from sensor cable delivers 15v !!!
 * Connect the output of the potentiometer to the blue wire (ADC1) for distance and green wire (ADC2) for steering on left sensor board cable
 * Connect the potentiometer/hall sensor to ground, ⚠️ On some boards, the black wire is 15v !!! Check with a multi-meter to make sure 15V and ground are not swapped
 * 100k Pull down resistors connected to ground are recommended to prevent issues when inputs are floating (wire is cut or disconnected) triggering ADC protection