diff --git a/ADC-Control.md b/ADC-Control.md
index e4e76bc..3d3f84d 100644
--- a/ADC-Control.md
+++ b/ADC-Control.md
@@ -26,10 +26,10 @@ Auto-calibration finds the minimum, middle and maximum values for ADC inputs.
 * Release potentiometers to the resting position
 * Press the power button to confirm or wait for the 20 sec timeout
 
-The limits will be stored in flash memory and will be erased only if you fully delete memory before flashing.<br />
+⚠The limits will be stored in flash memory and will be erased only if you fully delete memory before flashing.<br />
 An alternative to bypass those limits is to change **FLASH_WRITE_KEY** in config.h to a value different than 0x1234.
 
-⚠ Auto-calibration only works if both ADC inputs are connected/used.
+Auto-calibration only works if both ADC inputs are connected/used.
 
 
 # Extra Features
@@ -38,6 +38,9 @@ An alternative to bypass those limits is to change **FLASH_WRITE_KEY** in config
 * move and hold the pots to a desired limit position for Current(ADC1) and Speed(ADC2), maximum being the values you have put in config.h
 * press the power button to confirm or wait for the 10 sec timeout
 
+⚠The settings will be stored in flash memory and will be erased only if you fully delete memory before flashing.<br />
+An alternative to bypass those settings is to change **FLASH_WRITE_KEY** in config.h to a value different than 0x1234.
+
 ## Support of extra buttons:
 Uncomment #define **SUPPORT_BUTTONS_RIGHT** to use right sensor board cable for button inputs. Disable DEBUG_SERIAL_USART3!
 Variables button1 and button2 can be later used to implement different behavior