diff --git a/Variant-SKATEBOARD.md b/Variant-SKATEBOARD.md
index 62a8b98..ad97a81 100644
--- a/Variant-SKATEBOARD.md
+++ b/Variant-SKATEBOARD.md
@@ -25,4 +25,7 @@ This variant is expecting only one mid-resting input, calibration will be reject
 
 ## :toolbox: Troubleshooting:
 If the board is [beeping](https://github.com/EmanuelFeru/hoverboard-firmware-hack-FOC/wiki/Diagnostics)
-* Make sure you are using the sensor cable(left=CONTROL_PWM_LEFT or right=CONTROL_PWM_RIGHT) selected in config.h
\ No newline at end of file
+* Make sure you are using the sensor cable(left=CONTROL_PWM_LEFT or right=CONTROL_PWM_RIGHT) selected in config.h
+* You might have a defective input, because of a fried resistor or MCU pin (e.g. [issue](https://github.com/EFeru/hoverboard-firmware-hack-FOC/issues/244)), you can configure the firmware to work on the other cable
+
+If you get unwanted movements, check the wiring section.
\ No newline at end of file