Fix capitalize folder and file name ignored

src/Main/BoardDef.h

@@ -0,0 +1,88 @@
+#ifndef _AIR_GRADIENT_BOARD_DEF_H_
+#define _AIR_GRADIENT_BOARD_DEF_H_
+
+#include <Arduino.h>
+
+#if defined(ESP8266)
+#define AgLog(c, ...)                                                          \
+  if (this->_debugStream != nullptr) {                                         \
+    this->_debugStream->printf("[%s] " c "\r\n", this->TAG, ##__VA_ARGS__);    \
+  }
+#else
+#include <esp32-hal-log.h>
+#define AgLog(c, ...) log_i(c, ##__VA_ARGS__)
+#endif
+
+/**
+ * @brief Define Airgradient supported board type
+ */
+enum BoardType {
+  DIY_BASIC = 0x00,
+  DIY_PRO_INDOOR_V4_2 = 0x01,
+  ONE_INDOOR = 0x02,
+  OPEN_AIR_OUTDOOR = 0x03,
+  _BOARD_MAX
+};
+
+/**
+ * @brief Board definitions
+ * 
+ */
+struct BoardDef {
+  /** Board Support CO2 SenseS8 */
+  struct {
+    const int uart_tx_pin; /** UART tx pin */
+    const int uart_rx_pin; /** UART rx pin */
+    const bool supported;  /** Is BSP supported for this sensor */
+  } SenseAirS8;
+
+  /** Board Support Plantower PMS5003 */
+  struct {
+    const int uart_tx_pin; /** UART tx pin */
+    const int uart_rx_pin; /** UART rx pin */
+    const bool supported;  /** Is BSP supported for this sensor */
+  } Pms5003;
+
+  /** I2C Bus */
+  struct {
+    const int sda_pin;    /** I2C SDA pin */
+    const int scl_pin;    /** I2C SCL pin */
+    const bool supported; /** Is BSP supported I2C communication */
+  } I2C;
+
+  /** Switch */
+  struct {
+    const int pin;         /** Switch PIN */
+    const int activeLevel; /** Switch pressed level */
+    const bool supported;
+  } SW;
+
+  /** LED */
+  struct {
+    const int pin;           /** Pin control */
+    const int rgbNum;        /** Number of RGB LED */
+    const int onState;       /** Single LED turn on state */
+    const bool supported;    /** SUpported LED */
+    const bool rgbSupported; /** LED is RGB */
+  } LED;
+
+  /** OLED */
+  struct {
+    const uint8_t width;  /** Display Width */
+    const uint8_t height; /** Display height */
+    const uint8_t addr;   /** OLED I2C address */
+    const bool supported;
+  } OLED;
+
+  /** Watchdog */
+  struct {
+    const uint8_t resetPin;
+    const bool supported;
+  } WDG;
+  const char *name;
+};
+
+const BoardDef *getBoardDef(BoardType def);
+void printBoardDef(Stream *_debug);
+
+#endif /** _AIR_GRADIENT_BOARD_DEF_H_ */