#ifndef _AIR_GRADIENT_BOARD_DEF_H_
#define _AIR_GRADIENT_BOARD_DEF_H_

#include <Arduino.h>

#if defined(ESP8266)
#define AgLog(c, ...)                                                          \
  if (this->_debugStream != nullptr) {                                         \
    this->_debugStream->printf("[%s] " c "\r\n", this->TAG, ##__VA_ARGS__);    \
  }
#else
#include <esp32-hal-log.h>
#define AgLog(c, ...) log_i(c, ##__VA_ARGS__)
#endif

/**
 * @brief Define Airgradient supported board type
 */
enum BoardType {
  DIY_BASIC = 0x00,
  DIY_PRO_INDOOR_V4_2 = 0x01,
  ONE_INDOOR = 0x02,
  OPEN_AIR_OUTDOOR = 0x03,
  DIY_PRO_INDOOR_V3_3 = 0x04,
  _BOARD_MAX
};

/**
 * @brief Board definitions
 * 
 */
struct BoardDef {
  /** Board Support CO2 SenseS8 */
  struct {
    const int uart_tx_pin; /** UART tx pin */
    const int uart_rx_pin; /** UART rx pin */
    const bool supported;  /** Is BSP supported for this sensor */
  } SenseAirS8;

  /** Board Support Plantower PMS5003 */
  struct {
    const int uart_tx_pin; /** UART tx pin */
    const int uart_rx_pin; /** UART rx pin */
    const bool supported;  /** Is BSP supported for this sensor */
  } Pms5003;

  /** I2C Bus */
  struct {
    const int sda_pin;    /** I2C SDA pin */
    const int scl_pin;    /** I2C SCL pin */
    const bool supported; /** Is BSP supported I2C communication */
  } I2C;

  /** Switch */
  struct {
    const int pin;         /** Switch PIN */
    const int activeLevel; /** Switch pressed level */
    const bool supported;
  } SW;

  /** LED */
  struct {
    const int pin;           /** Pin control */
    const int rgbNum;        /** Number of RGB LED */
    const int onState;       /** Single LED turn on state */
    const bool supported;    /** SUpported LED */
    const bool rgbSupported; /** LED is RGB */
  } LED;

  /** OLED */
  struct {
    const uint8_t width;  /** Display Width */
    const uint8_t height; /** Display height */
    const uint8_t addr;   /** OLED I2C address */
    const bool supported;
  } OLED;

  /** Watchdog */
  struct {
    const int resetPin;
    const bool supported;
  } WDG;
  const char *name;
};

const BoardDef *getBoardDef(BoardType def);
const char *getBoardDefName(BoardType type);
void printBoardDef(Stream *_debug);

#endif /** _AIR_GRADIENT_BOARD_DEF_H_ */