arduino-esp32/tools/sdk/include/ethernet/eth_phy/phy_ip101.h

// Copyright 2015-2019 Espressif Systems (Shanghai) PTE LTD
//
// Licensed under the Apache License, Version 2.0 (the "License");
// you may not use this file except in compliance with the License.
// You may obtain a copy of the License at

//     http://www.apache.org/licenses/LICENSE-2.0
//
// Unless required by applicable law or agreed to in writing, software
// distributed under the License is distributed on an "AS IS" BASIS,
// WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
// See the License for the specific language governing permissions and
// limitations under the License.

#pragma once

#ifdef __cplusplus
extern "C" {
#endif

#include "phy.h"

/**
 * @brief Dump IP101 PHY SMI configuration registers
 *
 */
void phy_ip101_dump_registers();

/**
 * @brief Default IP101 phy_check_init function
 *
 */
void phy_ip101_check_phy_init(void);

/**
 * @brief Default IP101 phy_get_speed_mode function
 *
 * @return eth_speed_mode_t Ethernet speed mode
 */
eth_speed_mode_t phy_ip101_get_speed_mode(void);

/**
 * @brief Default IP101 phy_get_duplex_mode function
 *
 * @return eth_duplex_mode_t Ethernet duplex mode
 */
eth_duplex_mode_t phy_ip101_get_duplex_mode(void);

/**
 * @brief Default IP101 phy_power_enable function
 *
 */
void phy_ip101_power_enable(bool);

/**
 * @brief Default IP101 phy_init function
 *
 * @return esp_err_t
 *      - ESP_OK on success
 *      - ESP_FAIL on error
 */
esp_err_t phy_ip101_init(void);

/**
 * @brief Default IP101 PHY configuration
 *
 * @note This configuration is not suitable for use as-is,
 * it will need to be modified for your particular PHY hardware setup.
 *
 */
extern const eth_config_t phy_ip101_default_ethernet_config;

#ifdef __cplusplus
}
#endif