esp-idf/components/usb/usb_phy_p4.c

/*
 * SPDX-FileCopyrightText: 2024 Espressif Systems (Shanghai) CO LTD
 *
 * SPDX-License-Identifier: Apache-2.0
 */

// This is only a dummy USB PHY file for successful linking of ESP32-P4 target
// The internal HS PHY is enabled by default, therefore it needs no configuration

// TODO: Refactor during the IDF-9198
#include "sdkconfig.h"
#include "soc/usb_dwc_cfg.h"
#include "hal/usb_wrap_hal.h"
// TODO: Remove this file when proper support of P4 PHYs is implemented IDF-7323
#include "esp_private/usb_phy.h"

esp_err_t usb_new_phy(const usb_phy_config_t *config, usb_phy_handle_t *handle_ret)
{
#if (OTG_HSPHY_INTERFACE != 0)
#if CONFIG_IDF_TARGET_ESP32P4
    /*
    Additional setting to solve missing DCONN event on ESP32P4 (IDF-9953).

    Note: On ESP32P4, the HP_SYSTEM_OTG_SUSPENDM is not connected to 1 by hardware.
    For correct detection of the device detaching, internal signal should be set to 1 by the software.
    */
    usb_wrap_ll_enable_precise_detection();
#endif // CONFIG_IDF_TARGET_ESP32P4
#endif // (OTG_HSPHY_INTERFACE != 0)
    return ESP_OK;
}

esp_err_t usb_del_phy(usb_phy_handle_t handle)
{
    return ESP_OK;
}

esp_err_t usb_phy_get_phy_status(usb_phy_target_t target, usb_phy_status_t *status)
{
    return ESP_OK;
}

esp_err_t usb_phy_action(usb_phy_handle_t handle, usb_phy_action_t action)
{
    return ESP_OK;
}