diff --git a/components/esp_phy/Kconfig b/components/esp_phy/Kconfig
index 1e380ff9c5..646522e499 100644
--- a/components/esp_phy/Kconfig
+++ b/components/esp_phy/Kconfig
@@ -113,4 +113,28 @@ menu "PHY"
             When using USB Serial/JTAG/OTG/CDC, PHY should enable USB, otherwise USB module
             can not work properly. Notice: Enabling this configuration option will slightly impact wifi performance.
 
+    choice ESP_PHY_CALIBRATION_MODE
+        prompt "Calibration mode"
+        default ESP_PHY_RF_CAL_PARTIAL
+        help
+            Select PHY calibration mode. During RF initialization, the partial calibration
+            method is used by default for RF calibration. Full calibration takes about 100ms
+            more than partial calibration. If boot duration is not critical, it is suggested
+            to use the full calibration method. No calibration method is only used when the
+            device wakes up from deep sleep.
+
+        config ESP_PHY_RF_CAL_PARTIAL
+            bool "Calibration partial"
+        config ESP_PHY_RF_CAL_NONE
+            bool "Calibration none"
+        config ESP_PHY_RF_CAL_FULL
+            bool "Calibration full"
+    endchoice #ESP_PHY_CALIBRATION_MODE
+
+    config ESP_PHY_CALIBRATION_MODE
+        int
+        default 0 if ESP_PHY_RF_CAL_PARTIAL
+        default 1 if ESP_PHY_RF_CAL_NONE
+        default 2 if ESP_PHY_RF_CAL_FULL
+
 endmenu  # PHY
diff --git a/components/esp_phy/src/phy_init.c b/components/esp_phy/src/phy_init.c
index 10f9c780bd..df70f8333d 100644
--- a/components/esp_phy/src/phy_init.c
+++ b/components/esp_phy/src/phy_init.c
@@ -711,7 +711,7 @@ void esp_phy_load_cal_and_init(void)
 #endif
 
 #ifdef CONFIG_ESP_PHY_CALIBRATION_AND_DATA_STORAGE
-    esp_phy_calibration_mode_t calibration_mode = PHY_RF_CAL_PARTIAL;
+    esp_phy_calibration_mode_t calibration_mode = CONFIG_ESP_PHY_CALIBRATION_MODE;
     uint8_t sta_mac[6];
     if (esp_rom_get_reset_reason(0) == RESET_REASON_CORE_DEEP_SLEEP) {
         calibration_mode = PHY_RF_CAL_NONE;