diff --git a/examples/storage/sd_card/sdmmc/main/Kconfig.projbuild b/examples/storage/sd_card/sdmmc/main/Kconfig.projbuild
index 2b2a81aff8..0ed9817a06 100644
--- a/examples/storage/sd_card/sdmmc/main/Kconfig.projbuild
+++ b/examples/storage/sd_card/sdmmc/main/Kconfig.projbuild
@@ -22,7 +22,8 @@ menu "SD/MMC Example Configuration"
             bool "1 line (D0)"
     endchoice
 
-    if SOC_SDMMC_USE_GPIO_MATRIX
+
+    if IDF_TARGET_ESP32S3
 
         config EXAMPLE_PIN_CMD
             int "CMD GPIO number"
@@ -52,6 +53,6 @@ menu "SD/MMC Example Configuration"
 
         endif  # EXAMPLE_SDMMC_BUS_WIDTH_4
 
-    endif  # SOC_SDMMC_USE_GPIO_MATRIX
+    endif  # IDF_TARGET_ESP32S3
 
 endmenu
diff --git a/examples/storage/sd_card/sdmmc/main/sd_card_example_main.c b/examples/storage/sd_card/sdmmc/main/sd_card_example_main.c
index 9f7ef71c76..baf9f4ac3e 100644
--- a/examples/storage/sd_card/sdmmc/main/sd_card_example_main.c
+++ b/examples/storage/sd_card/sdmmc/main/sd_card_example_main.c
@@ -61,7 +61,7 @@ void app_main(void)
 
     // On chips where the GPIOs used for SD card can be configured, set them in
     // the slot_config structure:
-#ifdef CONFIG_SOC_SDMMC_USE_GPIO_MATRIX
+#ifdef CONFIG_IDF_TARGET_ESP32S3
     slot_config.clk = CONFIG_EXAMPLE_PIN_CLK;
     slot_config.cmd = CONFIG_EXAMPLE_PIN_CMD;
     slot_config.d0 = CONFIG_EXAMPLE_PIN_D0;
@@ -70,7 +70,7 @@ void app_main(void)
     slot_config.d2 = CONFIG_EXAMPLE_PIN_D2;
     slot_config.d3 = CONFIG_EXAMPLE_PIN_D3;
 #endif  // CONFIG_EXAMPLE_SDMMC_BUS_WIDTH_4
-#endif  // CONFIG_SOC_SDMMC_USE_GPIO_MATRIX
+#endif  // CONFIG_IDF_TARGET_ESP32S3
 
     // Enable internal pullups on enabled pins. The internal pullups
     // are insufficient however, please make sure 10k external pullups are