diff --git a/components/driver/spi_master.c b/components/driver/spi_master.c
index 0dc99f745a..90c8b0aedb 100644
--- a/components/driver/spi_master.c
+++ b/components/driver/spi_master.c
@@ -389,10 +389,6 @@ esp_err_t spi_bus_add_device(spi_host_device_t host, const spi_device_interface_
     int freq;
     spi_hal_context_t *hal = &spihost[host]->hal;
     hal->half_duplex = dev_config->flags & SPI_DEVICE_HALFDUPLEX ? 1 : 0;
-#ifdef SOC_SPI_SUPPORT_AS_CS
-    hal->as_cs = dev_config->flags & SPI_DEVICE_CLK_AS_CS ? 1 : 0;
-#endif
-    hal->positive_cs = dev_config->flags & SPI_DEVICE_POSITIVE_CS ? 1 : 0;
     hal->no_compensate = dev_config->flags & SPI_DEVICE_NO_DUMMY ? 1 : 0;
 
     spi_hal_timing_conf_t temp_timing_conf;
@@ -502,9 +498,7 @@ static void SPI_MASTER_ISR_ATTR spi_setup_device(spi_host_t *host, int dev_id)
     hal->mode = dev->cfg.mode;
     hal->tx_lsbfirst = dev->cfg.flags & SPI_DEVICE_TXBIT_LSBFIRST ? 1 : 0;
     hal->rx_lsbfirst = dev->cfg.flags & SPI_DEVICE_RXBIT_LSBFIRST ? 1 : 0;
-    hal->no_compensate = dev->cfg.flags & SPI_DEVICE_NO_DUMMY ? 1 : 0;
     hal->sio = dev->cfg.flags & SPI_DEVICE_3WIRE ? 1 : 0;
-    hal->dummy_bits = dev->cfg.dummy_bits;
     hal->cs_setup = dev->cfg.cs_ena_pretrans;
     hal->cs_hold =dev->cfg.cs_ena_posttrans;
     //set hold_time to 0 will not actually append delay to CS
@@ -512,6 +506,12 @@ static void SPI_MASTER_ISR_ATTR spi_setup_device(spi_host_t *host, int dev_id)
     if (hal->cs_hold == 0) hal->cs_hold = 1;
     hal->cs_pin_id = dev_id;
     hal->timing_conf = &dev->timing_conf;
+    hal->half_duplex = dev->cfg.flags & SPI_DEVICE_HALFDUPLEX ? 1 : 0;
+#ifdef SOC_SPI_SUPPORT_AS_CS
+    hal->as_cs = dev->cfg.flags & SPI_DEVICE_CLK_AS_CS ? 1 : 0;
+#endif
+    hal->positive_cs = dev->cfg.flags & SPI_DEVICE_POSITIVE_CS ? 1 : 0;
+    hal->no_compensate = dev->cfg.flags & SPI_DEVICE_NO_DUMMY ? 1 : 0;
 
     spi_hal_setup_device(hal);
 
@@ -652,7 +652,6 @@ static void SPI_MASTER_ISR_ATTR spi_new_trans(spi_device_t *dev, spi_trans_priv_
     hal->rx_bitlen = trans->rxlength;
     hal->rcv_buffer = (uint8_t*)host->cur_trans_buf.buffer_to_rcv;
     hal->send_buffer = (uint8_t*)host->cur_trans_buf.buffer_to_send;
-    hal->half_duplex = dev->cfg.flags & SPI_DEVICE_HALFDUPLEX ? 1 : 0;
     hal->cmd = trans->cmd;
     hal->addr = trans->addr;
     //Set up QIO/DIO if needed