// DotStarTest // This example will cycle between showing four pixels as Red, Green, Blue, White // and then showing those pixels as Black. // // There is serial output of the current state so you can confirm and follow along // #include const uint16_t PixelCount = 4; // this example assumes 4 pixels, making it smaller will cause a failure // make sure to set this to the correct pins const uint8_t DotClockPin = 9; const uint8_t DotDataPin = 8; uint16_t colorSaturation=32768; // for software bit bang, with Rgb48Color NeoPixelBus strip(PixelCount, DotClockPin, DotDataPin); // for hardware SPI (best performance but must use hardware pins) //NeoPixelBus strip(PixelCount); // Rgbw64Color implementation // NeoPixelBus strip(PixelCount, DotClockPin, DotDataPin); Rgb48Color red(colorSaturation, 0, 0); Rgb48Color green(0, colorSaturation, 0); Rgb48Color blue(0, 0, colorSaturation); Rgb48Color white(colorSaturation); Rgb48Color black(0); // for use with RGB DotStars when using the luminance/brightness global value // note that its range is only 0 - 31 (31 is full bright) and // also note that it is not useful for POV displays as it will cause more flicker Rgbw64Color redL(colorSaturation, 0, 0, 31); // use white value to store luminance Rgbw64Color greenL(0, colorSaturation, 0, 31); // use white value to store luminance Rgbw64Color blueL(0, 0, colorSaturation, 31); // use white value to store luminance Rgbw64Color whiteL(colorSaturation, colorSaturation, colorSaturation, colorSaturation / 8); // luminance is only 0-31 void setup() { Serial.begin(115200); while (!Serial); // wait for serial attach Serial.println(); Serial.println("Initializing..."); Serial.flush(); // this resets all the neopixels to an off state strip.Begin(); strip.ClearTo(black); strip.Show(); Serial.println(); Serial.println("Running..."); } void loop() { delay(5000); Serial.println("Colors R, G, B, W..."); // set the colors, strip.SetPixelColor(0, red); strip.SetPixelColor(1, green); strip.SetPixelColor(2, blue); strip.SetPixelColor(3, white); strip.Show(); delay(5000); Serial.println("Off ..."); // turn off the pixels strip.SetPixelColor(0, black); strip.SetPixelColor(1, black); strip.SetPixelColor(2, black); strip.SetPixelColor(3, black); strip.Show(); }