Correct comments

User_Setups/Setup23_TTGO_TM.h

@@ -35,6 +35,6 @@
 #define SMOOTH_FONT
 
 #define SPI_FREQUENCY  40000000     // This display also seems to work reliably at 80MHz
-#define SPI_FREQUENCY  80000000
+//#define SPI_FREQUENCY  80000000
 
 #define SPI_READ_FREQUENCY  6000000 // 6 MHz is the maximum SPI read speed for the ST7789V

User_Setups/Setup25_TTGO_T_Display.h

@@ -1,9 +1,9 @@
-// Setup for the TTGO T4 ("Bitcoin Tracker") ESP32 board with 2.2" ILI9341 display
+// Setup for the TTGO T Display
 
 // See SetupX_Template.h for all options available
 
 #define ST7789_DRIVER
-#define TFT_SDA_READ   // Display has a bidirectionsl SDA pin
+#define TFT_SDA_READ   // Display has a bidirectional SDA pin
 
 #define TFT_WIDTH  135
 #define TFT_HEIGHT 240
@@ -33,7 +33,7 @@
 #define SMOOTH_FONT
 
 //#define SPI_FREQUENCY  27000000
-  #define SPI_FREQUENCY  40000000   // Maximum for ILI9341
+  #define SPI_FREQUENCY  40000000
 
 
 #define SPI_READ_FREQUENCY  6000000 // 6 MHz is the maximum SPI read speed for the ST7789V

User_Setups/Setup35_ILI9341_STM32_Port_Bus.h

@@ -7,10 +7,12 @@
 // Define STM32 to invoke STM32 optimised driver
 #define STM32
 
-// Define if Port A (or B) pins 0-7 are used for data bus bits 0-7
+// Define if Port A (B, C or D) pins 0-7 are used for data bus bits 0-7
 // this will improve rendering performance by a factor of ~8x
 #define STM_PORTA_DATA_BUS
 //#define STM_PORTB_DATA_BUS // Pins below must re re-allocated to use this option
+//#define STM_PORTC_DATA_BUS // Pins below must re re-allocated to use this option
+//#define STM_PORTD_DATA_BUS // Pins below must re re-allocated to use this option
 
 // Tell the library to use 8 bit parallel mode (otherwise SPI is assumed)
 #define TFT_PARALLEL_8_BIT