Use Quay as the source for the nginx-unprivileged image used for the
Multus validation tool because Quay does not rate limit image pulls,
which are a common complaint for users of the tool.
Signed-off-by: Blaine Gardner <blaine.gardner@ibm.com>
Add the ability to specify node profiles in the multus validation test.
This addresses a few points of early feedback on the validation tool.
Statements below critique the tool's behavior before this patch.
1. The tool assumes all daemons are on public and cluster network, which
means users who have a significantly smaller cluster net (a
design choice) cannot run a single test to determine if Rook is
likely to install correctly.
2. The tool does not have placement options to select only a subset of
Kubernetes nodes to run validation on.
3. Users of multus seem to have a dedicated pool of storage nodes more
often than the average Rook install. This makes sense for security-
and perforance-minded users. The tool cannot run a single test to
verify storage-only and general-workload nodes at one time.
These points are addressed by allowing users to specify configurations
for different "NodeTypes."
Each NodeType config has options for selecting the number of OSDs as
well as the number of other (non-OSD) Ceph daemons. This limits the
unnecessary exhaustion of cluster network addresses from critique 1.
Each NodeType config has its own placement (critique 2).
Users can define as many NodeTypes as needed to test the network for
their planned CephCluster. Specifically, this allows the tool to test
storage-only nodes and generalized-workload nodes at the same time. An
arbitrary number of NodeTypes are allowed to support even more highly
specialized cluster setups, such as multiple tiers of storage nodes
where some storage-only nodes may run more OSDs than others.
Signed-off-by: Blaine Gardner <blaine.gardner@ibm.com>
Signed-off-by: Michael Adam <obnox@samba.org>
this change introduces a new 'make target 'docs'that generates part of the documentation
It particular, it runs the `helm-docs` target.
Additionally, `make docs` updates the multus validation job manifest
by inserting the output of `rook multus validation run --help` between
two newly introduced markers.
The result of running `make docs` is intended to be committed to git after running
Fixes: #12706
Signed-off-by: Michael Adam <obnox@samba.org>
Signed-off-by: Blaine Gardner <b.blaine.gardner@gmail.com>
Co-authored-by: Blaine Gardner <b.blaine.gardner@gmail.com>
Co-authored-by: Michael Adam <obnox@samba.org>
Update build/deploy/generate-deploy-examples.sh
Signed-off-by: Michael Adam <obnox@samba.org>
added a sample job manifest named `multus-validation` that
validates the multus configuration in the cluster.
Signed-off-by: Nikhil-Ladha <nikhilladha1999@gmail.com>
Blaine Gardner
Sheetal Pamecha
Michael Adam
Nikhil-Ladha